Steering & Suspension

Chair, VW Polo Sedan, front left wheel area

Chair, VW Polo Sedan, front left wheel area
The foot, especially the roughness, may be caused by the occurrence of the movement of the steering wheel. Often the cause of the knocking is the steering gear tuner on the right

What is the reason for the play in the VW Polo Sedan gear rack?

What is the reason for the play in the VW Polo Sedan gear rack?
The most common cause of the trip is the high mileage of Polo Sedan (25-30 thousand km) Causes-frequent trips on roughness, pollution. A new tulk must be installed to correct the problem

VW Polo Sedan moves in the direction of motion

VW Polo Sedan moves in the direction of motion
This lack of Polo Sedan is known to the producer, and since 2012 it has already been removed, with the rudder slightly heavier. In cars up to the 2012 model year, the driver's problem was either the replacement of the power steering, or the stimching of the steering wheel

WW Tiguan suspension

WW Tiguan suspension
The syrup in the Tigran's suspension publishes the site blocks. Especially this creak is in the cold, for example, in the passage of the police officers. Unfortunately, even the replacement of the site with the new, original, problem will not solve the problem. The whole thing is about the constructive features of the last.

Remove and disassemble the rear racks to replace the shock absorbers on the VW Tiguan

Remove and disassemble the rear racks to replace the shock absorbers on the VW Tiguan
-Remove the back wheel,-Remove the wheel arch,-Eject the spring spring, it must be compressed by a special tool (VAG 1752/ 1),-twist two M10x35 screws at the top of the shock absorber,-Press the lower screw of the M14x1,5x85 shock absorber. -Remove the shock absorber

Challenges to the Volkswagen Touareg II (NF) suspension

Challenges to the Volkswagen Touareg II (NF) suspension
The suspension of the Volkswagen Tuareg 2 may be both spring-loaded and pneumatic. The standard spring-loaded suspension is distinguished by high noise when moving on roughness, but is sufficiently reliable

dismantling of the Pneumswoproof in a Volkswagen Touareg II (NF)

dismantling of the Pneumswoproof in a Volkswagen Touareg II (NF)
The removal of the pneumatic-air cushioning frame on the Volkswagen Tuareg 2 shall be carried out in this sequence: (1) Pneumatic-resistant to the vehicle

Volkswagen Touareg II (NF) suspension

Volkswagen Touareg II (NF) suspension
By adjusting the suspension of the suspension on Volkswagen Toareg 2, you can adapt the car to certain road conditions. The adjustment is made by the checkbox at the bottom of the central console and implies a choice between three modes:-Comfort

Lifter Installation Mode in Volkswagen Touareg II (NF)

Lifter Installation Mode in Volkswagen Touareg II (NF)
The installation mode of the lift should be installed on the Volkswagen Tuareg 2 with a system for regulating the ground clearance when it is raised by a jack, a tow truck or a lift

Replacement of the pneumatic compressor for the Volkswagen Touareg II (NF)

Replacement of the pneumatic compressor for the Volkswagen Touareg II (NF)
To remove the air suspension compressor for Volkswagen Tuareg 2, it is necessary to: 1) Reset the pressure in the system by test2) Enable lift of the car to the lift and lift auto.3) Clear the handle and disconnect the air intake hose.