- Details
-
February 11, 2022
-
Written by Jason Hance
Replacement of hydraulic steering pump at the Opel Vetra B (with the Y16XE engine) shall be replaced by: (1) Remove an air filter (2)) Using the "15" key with a "on" clockwise reel of the wheel belt of the auxiliary units
- Details
-
February 10, 2022
-
Written by Jason Hance
The procedure for replacing the bearing bearings on the Opel Vektra C is as follows: (1) Lift the wheel and remove the wheel (2) Remove the brake hose and pull it off the side of the ABS)
- Details
-
February 08, 2022
-
Written by Jason Hance
Procedure to replace the front of the Bonus Bonus with: (1) Lift the vehicle and take off the hourglass
- Details
-
February 07, 2022
-
Written by Jason Hance
To change the front buffers to the Opel Vektra V, you must: 1) Open the hood and remove the protective cap on the cushions. 2) The key "on 18" unscrew the nut (not the end) by adhering to the other keys.
- Details
-
February 05, 2022
-
Written by Jason Hance
Conduct replacement of the steps bearings on the Opel of Vektra B in this order: (1) Lift the wheel and take off the wheel 2) Take off the turnkey) With the help of the press and a suitable pipe, remove the hub from the swivel
- Details
-
February 04, 2022
-
Written by Jason Hance
Replacement of the tip of the steering gear on the Opel of Vectra in the sequence: (1) Raise the vehicle and remove the front wheel (.2)
- Details
-
February 02, 2022
-
Written by Jason Hance
In order to change the heads of steering gear on the Opel Vektra C, we need to do the following: (1) Raise the front wheels and remove the front wheels.) Meri the length of the free threaded part of the traction, or count the number of turns
- Details
-
February 01, 2022
-
Written by Jason Hance
The ball support on the Opel Vectra is changed in this sequence: (1) Lift the vehicle, remove the front wheel 2)
- Details
-
January 30, 2022
-
Written by Jason Hance
Replace the stabilizer rack on the Opel Vector with the following: (1) Lift the wheel and take off the wheel 2) Process the screws and nuts WD-4.3) by holding the key "on 17", lifting the two nut clips with the key "18" .4) Install the new stabilizer foot.
- Details
-
January 29, 2022
-
Written by Jason Hance
The procedure for replacing the rear shock absorbers on Opel Vektra B is as follows: (1) Lift the wheel and take off the hed.2)