- Details
-
January 27, 2022
-
Written by Jason Hance
To replace the rear flaps of the longitudinal levers on the Opel Vectra V: 1) The back of the car and filmed (.2)) With a thin piece of chalk, round the back of the longitudinal lever
- Details
-
January 26, 2022
-
Written by Jason Hance
To change the rear thrust of the stabilizer and the tuller to the Vektra C, we do the following procedure: (1) Install the car on the yame2)
- Details
-
January 24, 2022
-
Written by Jason Hance
To the wrong wheel roll, the Peugeot 206 rear axle will result in the failure of the rear suspension igolers. It's not worth it, otherwise I'll have to change the whole back beam.
- Details
-
January 22, 2022
-
Written by Jason Hance
The script is generated when the rudder is rotated. Usually disappears after the injection of silicon glue between the rudder and the crochet. Also, the reason for the sound may be that the plumes, which go to the airbag, are three in the plastic. The problem is solved with the lubricant
- Details
-
January 21, 2022
-
Written by Jason Hance
If Ren Duster's steering wheel turns, the reasons may be the most varied, but most often the source of the extraneous sound is the steering gear. The manufacturer knows about this defect, so the Renault Duster's violin gear changes under warranty
- Details
-
January 19, 2022
-
Written by Jason Hance
The pump of the electric power-assisted pump on Reno Duster is a known problem. The heat may also start in a new car. The pipe is on the left side on the imitation. As a general rule, the disadvantage is addressed in the framework of the guarantee obligations
- Details
-
January 18, 2022
-
Written by Jason Hance
In the parking lot, random clicks were heard and sparked the wiring in the steering column? The problem with the electronics on Fluence is rare. Probably caused by sparks are problems with one of the steering column trailers
- Details
-
January 16, 2022
-
Written by Jason Hance
The ball support is one of the main elements of the suspension. Due to the fact that the lubricating oil in the ball at low temperature is frozen, sounds are heard, similar to the grinding (in contrast to the shrouding, this sound without clicking). This is a problem for many [ [ Fluence]] s
- Details
-
January 15, 2022
-
Written by Jason Hance
The riders often think that the temperature of the Renault Fluency begins to creak the cushioning racks themselves. However, much more often, the creators of the stabilizer are issuing original stabilizer racks. They are made of material that changes properties when the temperature drops
- Details
-
January 13, 2022
-
Written by Jason Hance
The stabilizer is likely to be creak (the rubber band is pressed to the body) of the transverse stability stabilizer. Rubber is worn out and, over time, begins to make a squeaky sound. It is desirable to periodically smear the rubber with silicone grease