Electrical equipment

Checking the engine of the windshield washer on the Honda Civil 8

Checking the engine of the windshield washer on the Honda Civil 8
To check the engine of the windscreen washer on the Honda Civil 8: Demote the right shield of the engine compartment. Disconnect the "2P" connectors of the pump engine

Checking the ignition of the Honda Civil 8

Checking the ignition of the Honda Civil 8
To check the ignition locking system at Honda Civil 8, it is necessary to remove the upper and lower covers of the steering column. Connect the connector "6P". The LED light emitting diode (LED) must be turned on if the power is connected to the terminals of "No 6" and the "No. 5" cell is connected to the "mass"

Check the ignition switch on Honda Civil

Check the ignition switch on Honda Civil
To check the ignition switch on Honda Civil 8: Disassemble the upper and lower cover of the steering column. Disconnect the "6P" connector. Insert key into the ignition locking system and verify that the connection between the terminals "No 1" and "No. 2" is connected

Removing and installing the Honda Civil 8 generator

Removing and installing the Honda Civil 8 generator
To remove the generator on Honda Civic 8, you need to disable the JSCs and remove the drive belt. Disconnect the generator connector and the black wire (BLK) from the generator. Disconnect the connector and the wiring harnesses from the generator.

Installing the headlight button on the Honda Civil 8

Installing the headlight button on the Honda Civil 8
To install the headlights button on the Honda Civil 8 4d, you need to remove the lower bezel from the driver, remove the plastic sidewall and unscrew one side of the side-side

Replacing the HID block with Honda Civil 8

Replacing the HID block with Honda Civil 8
To replace the HID block on Honda Civil 8: Disable ACBA. Then remove the HID.Remove HID light from the HID unit by removing the three screws. Installing the HID unit in reverse order

Replacing the headlamps with Honda Civil 8

Replacing the headlamps with Honda Civil 8
To replace the headlamps on the Honda Civil 8: Unmount the front bumper. Disconnect the connectors from the headlamp unit. Remove the corner bar from the lamp body by unfixing the mounting bolt

Replacing the HID lamp with Honda Civil 8

Replacing the HID lamp with Honda Civil 8
It is prohibited to turn on the light of the central switch until the full installation of the gas-filled HID lamps into its cartridges and until the end of the headlamp assembly.

Replacement of windscreen wiper engine at Honda Civil 8

Replacement of windscreen wiper engine at Honda Civil 8
To replace the windscreen wiper engine at Honda Civil ivic 8: Open the hood and remove the flaps, nuts and bolts of the wiper blade.

Replacement of a Headlamp patrolling in the Honda Civil

Replacement of a Headlamp patrolling in the Honda Civil
In order to replace the headlights of the Honda Civil 8, it is necessary to: Unmount the front bumper and disconnect the headlight tube from the electric motor of the headlamps.