- Details
-
January 15, 2023
-
Written by Jason Hance
Initially, you must unmount the upper part of the cover by turning the rudder 90 degrees to the left and then to the right. There are latches that can be used to drive a flat-blade screwdriver. Now you can pull the cover up and get it off.
- Details
-
January 14, 2023
-
Written by Jason Hance
The banging in the helmsman gear is a known issue of the third generation Focus. A stool may appear in a new car and several years after the start of operation. The problem is solved by replacing the gear rack
- Details
-
January 13, 2023
-
Written by Jason Hance
Rhythmic creak in the area of the front wheel VAZ-2108/09/99, which is particularly noticeable when moving at a slow speed, may indicate that the hub bearings on this wheel are stretched
- Details
-
January 12, 2023
-
Written by Jason Hance
To reduce noise in the passenger compartment, they usually make noise and vibration. However, in the case of noise tyres, such a measure is unlikely to bring good results. To reduce noise, enthusiasts use a variety of designs
- Details
-
January 10, 2023
-
Written by Jason Hance
The most common problem is the appearance of bumps and at the right turns, and in some time-the appearance of a play in the steering wheel. In this case, the steering gear needs to be redrawn.
- Details
-
January 09, 2023
-
Written by Jason Hance
When obstacles are moved and driving on the uneven road to VAZ-2104/05/07, a loud knock on the side of one of the front wheels is often displayed
- Details
-
January 09, 2023
-
Written by Jason Hance
In Mondeo 4, the steering fluid of the Ford or Motorcraft or other specifications is required: WSS-M2C204-A2
- Details
-
January 07, 2023
-
Written by Jason Hance
The Ford Mondeo III arrowhead is located on the right and on the left, between the transverse rod steering and the gear lever. The equatorial arrowheads with a defective gauge or a gap shall be immediately replaced
- Details
-
January 06, 2023
-
Written by Jason Hance
In order to replace CMUS-VAZ-2108/09/99, the garage will require: a lift for the steering, 27, heads for 17 and 19, a special key for 30 for the steps and a lever (metal pipe), a flat scrap (for disconnection of the shaft and a PPC), the lubricant of the SHRU-4.C replacement procedure, and the procedure for replacing the SHRUP4.
- Details
-
January 06, 2023
-
Written by Jason Hance
It is recommended to regularly check the transverse lever on the Ford Mondeo III, as the shedding dirt and water turns the grease of the transverse lever into the abrasive paste. This results in corrosion of bearings and hinges