Steering & Suspension

When the violin was available in the area of the front suspension Pole, MK, the following possible causes are possible: 1. Piske is a bad belt of hydro-amplifier. It is usually shown when steering turns on roughness

The steering wheel was removed from the steering wheel to the following order: 1. Disconnecting the battery. 2. Driver's safety pillow. 3

The structure of the rear hub of cars of different VAZ families (VAZ 2108, 2109, 21099, 2110, 2111, 2112, 2113, 2114 or 2115) is similar, so the replacement of the bearing of the rear hub is made by one algorithm

There are quite a lot of reasons for knocking on the running part of Jill. Consider the most common: shock absorbers. The wear and other parts of the stabilizer and other parts of the suspension

Many of the owners of Gil MK complain about tapping the rudder while driving on small bumps. The problem usually lies in the increased movement of the helmsman at the helmsman's shaft

The pendant of VAZ-2104/05/07 is equipped with two ball supports on each side: top and bottom. It is necessary to remove the wheel to replace the ball supports. In order to be reliable under the body of a car, it is necessary to provide additional support so that no work is carried out on the jack

One of the peculiarities of Jill MK is that the rear springs are rather weak. As a result, when the rear of the car is loaded, the rear suspension is often displayed. The most common solution to this problem is the installation of [ [ air bag]] s for springs

The suspension of the wheels of Jill MK is distinguished by the following wheel installation angles: Front axle: 0 ° 30 '+/-45' (-0.5 ° +/-0.75 °). Corner of the angular axis 1 ° 46 '+/-45' (1.76 ° +/-0.75 °). Corner of the transverse axis 9 ° 54 +/-45 ' (9.90 ° +/-0.75 °)

Many third generation RX owners face this problem. The problem is caused by a plastic gears in the steering column, which is quickly worn, resulting in a play, rattled noise, and banging

In order to replace the heads of the helmsman's drive, the MK is required to have 13, 19 and 21 wrenches, a bar key, and a ball key, as well as a shuffler scarf. We work in this order. In the beginning, we remove the wheel on one side and spray on the fastenes with the wheel.