- Details
-
January 04, 2023
-
Written by Jason Hance
To check the spare progress of the Ford Mondeo III steering wheel, it is necessary to install the wheels in the straightest position. Then turn the wheels to the back.
- Details
-
January 03, 2023
-
Written by Jason Hance
This is a common problem in the cars of VAZ-2110, as well as (and especially!) in VAZ-2111 and VAZ-2112, in which the trunk is aligned with the passenger compartment (so extraneous sounds can be heard more distinctly)
- Details
-
January 03, 2023
-
Written by Jason Hance
The gear rack, acting from the Ford Mondeo III steering gear, is protected by rubber cuffs. The dirt or moisture changes the lubricant in the steering gear to the abrasive paste, thereby affecting the steering mechanism
- Details
-
January 01, 2023
-
Written by Jason Hance
The modern bearings of the back bridges can serve about 150,000 kilometres. Front-bridge bearings are tending fast. Wheeled bearings on Ford Mondeo III are installed in the assembly, so they are to be fully replaced if they are damaged
- Details
-
December 31, 2022
-
Written by Jason Hance
Even the new cars of the [ [ VAZ-2108/09/99]] showed a tendency to exit the direct trajectory during the acceleration, especially in the second gear
- Details
-
December 31, 2022
-
Written by Jason Hance
To remove the steering wheel angle sensor (VDC) on the Ford Mondeo III: disconnect the PSC and remove the driver's frontal airbag module
- Details
-
December 29, 2022
-
Written by Jason Hance
Over time, taps may appear when the rudder is rotated, and a play in the steering wheel may appear. There may be several reasons for this. The first is the least serious-worn steering nozzle. They need to be replaced with a pair
- Details
-
December 28, 2022
-
Written by Jason Hance
As a general rule, the appearance of "trotting" in the VAZ-2105 with proper suspension and correctly adjusted derelation is associated with the play in the steering gear and/or the pendulum steering lever
- Details
-
December 28, 2022
-
Written by Jason Hance
The deformed transverse lever in the Ford Mondeo III is to be fully replaced. To replace it with a handbrake and loosing the wheel nuts. Remove the car from the jack and dock the rear axle with the underrun. Then remove the front wheel
- Details
-
December 26, 2022
-
Written by Jason Hance
The july steering wheel of the MK shall not be more than 50 mm. For a normal rudder, 370 mm in diameter, the linear amount of the luft shall be within the range of 16 mm to 17 mm. It can be checked by noting the position on the wheel where the wheels turn on the right and left sides