- Details
-
October 09, 2022
-
Written by Jason Hance
If there's a stabilizer on Liang Solano, and there's no way of changing them, you can try temporarily removing the knock. To do this: Remove the defective frame using two keys 17-18
- Details
-
October 06, 2022
-
Written by Jason Hance
If you are heavily contaminated with a water amplifier on Lifan Solano, it is desirable to change it or to clean it. We're doing it like this: Scrolling off the cover and pumping the whole liquid out of it with a syringe. We're going to get the hoses off the back and the supply hoses.
- Details
-
October 03, 2022
-
Written by Jason Hance
In order to replace the front steps, the front desk on Lifan Solano performs the following: Take off the turning-sheet. With the lift, remove the bearings ring of the bearing. At the same time, it usually leaves half of the bearing ring of the bearing
- Details
-
September 30, 2022
-
Written by Jason Hance
The replacement of the steering gear on Lifane Solano will require the keys to 18, 19 and 21, the key column, and the hinges and pliers. How to do this: By placing a car on a lift or weighing the front with solid supports
- Details
-
September 27, 2022
-
Written by Jason Hance
To replace the ball support on Lifan Solano, you need keys 17 and 21, and hinges
- Details
-
September 24, 2022
-
Written by Jason Hance
The replacement of the rear shock absorbers on Lifan Solano can be done in this order: Unwind the bottom fastening of the shock absorber (it is desirable for this car to be put on the pit)
- Details
-
September 20, 2022
-
Written by Jason Hance
In order to check the presence of a luft in the Mazda 3 steering wheel, it is necessary first to display the front wheels directly, to shut down the engine and to start swinging the steering wheel from side to side. Free travel shall be immediately visible
- Details
-
September 17, 2022
-
Written by Jason Hance
To remove the front stabilizer on the Mazda 3 (I), you must remove the front side, stabilizer, and stabilizer brackets.
- Details
-
September 14, 2022
-
Written by Jason Hance
The first thing to do is to move the steering fist through a jack. After that, separate the pivot pin from the pivot arm and remove the three nuts at the top of the front shock absorber
- Details
-
September 11, 2022
-
Written by Jason Hance
The first thing to do is put the wheels straight, and then remove the steering wheel with a special lift. For this, it will be necessary to remove the holes in the heads of the steering bolts of the steering so that they can be turned off by a screwdriver