- Details
-
April 18, 2023
-
Written by Jason Hance
If Chery Tieggo's car became ill-managed, or when the car was moving in one direction, it means it's time to do the same thing.
- Details
-
April 16, 2023
-
Written by Jason Hance
On many Chery Tiggo with time, a nasty squeaking is heard from under the bonnet. The cause of the creak is the steering wheel. In order to get rid of the unpleasant sound, it is necessary to finish the liquid in the GFM (dextron 3) by 5 mm above the maximum mark
- Details
-
April 15, 2023
-
Written by Jason Hance
The problem of the wear of the gear rack on the Jeep Grand Cheroki WK is usually shown as knocking on roughness. There are three ways to resolve the problem: (1) Replacing the helms2) Replacement of the spring break spring break
- Details
-
April 15, 2023
-
Written by Jason Hance
The first thing you need to do is remove both the front suspension levers. Then you need to remove the stabilizer bracket on the transverse resistance. Remove the two screws that connect the imitation and the steering mechanism
- Details
-
April 13, 2023
-
Written by Jason Hance
Sooner or later, Tiggo appears to be creaking through the smooth roughness. The sound comes from the front suspension area. The sound is a rubber hose. On each side there is one such tulk. You can replace the rubber band or regularly pry them with silicone grease.
- Details
-
April 12, 2023
-
Written by Jason Hance
To replace the bottom joints of the front suspension Jeep Grand Cherokee WK performs this action: Ruping the car and removing the wheel.
- Details
-
April 11, 2023
-
Written by Jason Hance
To replace the front shock absorber, you need to lift the car and remove the front wheel.
- Details
-
April 10, 2023
-
Written by Jason Hance
The first thing to do is to remove the front shock absorber cover, and then remove the screw that connects the shock absorber to the back of the towing bracket.
- Details
-
April 09, 2023
-
Written by Jason Hance
The replacement of the forward hub on the Jeep Grand Cherokee WK may be necessary if the hub bearing is worn as it is not changed. How to do this: Turn off the ignition and get the key out of the lock so that no errors are made after repair
- Details
-
April 08, 2023
-
Written by Jason Hance
The front wheels must be reduced and placed on the floggings for reliability. It is necessary to detach the hydro-amplifier back line, attach the silicone hose to the return line, and drain the hydraulic amplifier fluid in the prepared capacity