Steering & Suspension

Details

Written by: Jason Hance

Also available:

Created: 07 June 2023

Change the rear order of the differential on a four-wheel-drive Audi 100 P4 in this sequence:

Details

Written by: Jason Hance

Also available:

Created: 06 June 2023

To change the ball support on Santa Fe requires: (1) Reduce the car and remove the wheel 2) Urine silicon grease of joints to better remove the two keys "by 19" unwind the front side of the unit. I can't get it out.

Details

Written by: Jason Hance

Also available:

Created: 06 June 2023

The replacement of the rear shock absorbers on the Aodi 100 4th generation (the front-end versions without adjustment of the ground clearance) is performed as follows: Rise and lift the wheel.

Details

Written by: Jason Hance

Also available:

Created: 04 June 2023

Procedure for the loading and pumping of the steering system at the 4th generation of the 4th generation Audi: Cleaning up the system filter.

Details

Written by: Jason Hance

Also available:

Created: 03 June 2023

To change the hydraulic amplifier's working fluid: (1) outweigh the front wheels. 2) Disconnect the return hose from the amplifier beam and cork the plaster. 3) Connect the flexible hose to the return hose and drain the liquid into the receptacle

Details

Written by: Jason Hance

Also available:

Created: 03 June 2023

The pendant on the fourth generation of 4th generation is not a big resource. The most common problems are the trapping and the tipping of depreciation racks after 30,000 feet. Lower-levers shuffiar base after 50-70 thousand

Details

Written by: Jason Hance

Also available:

Created: 01 June 2023

To pump the steering hydroamplifier to Audi A4 3 generation after repair work, it is necessary first of all to check the level of the liquid and if necessary to finish

Details

Written by: Jason Hance

Also available:

Created: 31 May 2023

On Solaris, rear shock absorbers from a number of other vehicles are suitable: 1. Original shock absorbers for Opel Astra H and their analogues. The order number is KYB 343307. The following shall be required from the work: The lower anchorage (1 mm thick, 12 m inside diameter, 14 mm outside).

Details

Written by: Jason Hance

Also available:

Created: 31 May 2023

The hermeticity of the steering control in A4 generation 4 is checked after repair work or in the case of a low level of fluid in the tank. Test method: Take off the noise and start the engine

Details

Written by: Jason Hance

Also available:

Created: 29 May 2023

Procedure for the removal of the Bonus Bonus at the 3rd generation Audi: Remove the wheel. Install the brake disc with one bolt. If there is an automatic correction headlight, disconnect the drive-level sensor from the supporting lever. Disconnect the ABS from the connector on the sub-port