- Details
-
June 18, 2023
-
Written by Jason Hance
It is only possible to change the back-level bearings of the back-hub bearings of the Aodi 100 4th generation. To do this: Rise the rear of the vehicle. Remove the wheel cap and pull out the splint from the bearings of the hub
- Details
-
June 17, 2023
-
Written by Jason Hance
The weakest points in the fourth generation of the fourth generation Audi are: The resource is a resource of about 30 to 50 thousand stabilizers. km The steering nozzle is a resource up to 40 ,000-50, 000 people. See the front suspension blocks-up to 60,000. km
- Details
-
June 16, 2023
-
Written by Jason Hance
Procedure for replacing the site: 1) Remove the wheel of the desired side (2) Bottom of the vehicle by removing the protective cover of the lower support leg. 3) If the bolts of the arm of the lever are sour-lubrication lubrication. 4) The upper and lower bolts of the lever
- Details
-
June 15, 2023
-
Written by Jason Hance
The front shock absorbers on the fourth generation of the fourth generation can be changed without removing the springs and the entire rack. This will require a 2069 or 33.5 mm special tool. ReplaceProcedure: Stunchway to the handbrake
- Details
-
June 14, 2023
-
Written by Jason Hance
In order to change the arrowheads of transverse traction at Audi 100 C4, do the following: Take off the wheel of the self-counter in the wheelhouse.
- Details
-
June 13, 2023
-
Written by Jason Hance
The most common problem is the front steps of the bearing. In this case, you need to tighten the front cage nut. But it usually only helps for a little while. Then we have to pull the nut again periodically. 50 to 70 thousand
- Details
-
June 12, 2023
-
Written by Jason Hance
On the 4x4 birth of the fourth generation, the fourth generation, the rear suspension was installed. To replace the lever: Raise the car and remove the wheel.
- Details
-
June 11, 2023
-
Written by Jason Hance
Switch on the front suspension unit of the front of the Audi 100 P4 in this sequence: Pull the front of the car up front and remove the wheel. Pull off the battery.
- Details
-
June 10, 2023
-
Written by Jason Hance
The front depreciation pamps on the second generation of Santa Fe are changing in this sequence: (1) Unplug wheel 2) Disconnect the brake hose from the rack
- Details
-
June 09, 2023
-
Written by Jason Hance
To replace the steering wheel hose with the motor 2.8 liters of the fourth generation, 2.8 liter: Remove the plastic cover of the engine.