Engine

The need to purge the injector is one of the most hotly discussed motorists. Some say with certainty that cleaning is absolutely useless and does not produce any results

Many face the problem of carving into the HM studs on the 083 models, and not just them. There are several options for solving the problem, but only one is the repair pin of the carving

Starter's job is to spin the engine crankshaft to make the ignition system work.

Most often, the car owners are facing a situation in which, after turning the key in the ignition, the starter does not spin, but only clicks and the machine does not start

The concept of "compression ratio" refers to piston engines that have a combustion chamber

The engine can be tucked in, but you can just throw the old one and set it up. If the new engine is different from the old one, this action is called Swap (English word "swap").As a rule, the car is powered by a more powerful engine than it was before

The new filament is used for internal combustion diesel engines. Its role, above all, is the heating of the air in the cylinder of the engine, until it is started

Spark plugs are part of the ignition system, fuel-fuel-air mixture in the combustion chamber of the internal combustion engine

Many car owners are complaining about the whistling belt, in particular the belt of the generator. The belt of the alternator can be seen in different modes of operation of the vehicle and for various reasons. Cold start during warm-up

Motor oil can flow from the engine for various reasons, but any one should be able to be localized and eliminated in a timely way, because the oil fasting is damaging to any engine and decreasing its resource. The following are the most common causes of oil spillage: 1